HOMAG · BRANDT · SERVICE & REPAIR

Homag and Brandt edge bander service and repair

I service Homag and Brandt edge banders on site across Metro Vancouver and British Columbia — electrical and control faults, electronic boards, glue units, trimming and scraping, and preventive maintenance.

Mahyar beside a Brandt Optimat edgebander on site
On site at a Brandt Optimat edgebander.
EXPERIENCE

Homag and Brandt machines in local shops

Brandt edge banders, part of the Homag group, are common in cabinet shops around Vancouver, and many have been running for years. I have repaired and set up a range of them, from compact KDF models to older machines.

Whether the problem is a stop with an error, a glue unit that won’t hold, or trimming that no longer runs clean, the approach is the same: find the real cause, fix it properly and set the machine up for the edges you run.

MACHINES I HAVE SERVICED
  • Brandt KDF 110, KDF 440 and KDF 530 C
  • Brandt KD 54
  • Other Homag edge banders
WHAT I DO ON HOMAG MACHINES

Service for the whole machine

Electrical & control systems →

Controller and drive faults, sensors and safety circuits.

Electronic board repair →

Board-level repair of panels and boards.

Mechanical & pneumatic systems →

Glue units, pressure, trimming and scraping adjusted for a clean edge.

Maintenance & installation →

Preventive maintenance, calibration and set-up.

ON THE JOB

From recent service visits

Mahyar beside a Homag edgebander
On site at a Homag edgebander.
QUESTIONS

Frequently asked

Do you service Brandt edge banders?

Yes. Brandt is part of the Homag group, and I have serviced several Brandt KDF and KD models in local shops.

Are you a Homag service partner?

No. I am an independent technician. I service Homag and Brandt machines directly at your shop.

What should I send before the visit?

A photo of the name plate, the error message if there is one, and a short video of the problem.

Machine down? Get in touch.

Call or text with the machine brand and model and what it is doing. A photo of the name plate and a short video of the fault help a lot. Monday to Friday 8:00 am – 6:00 pm, Saturday 9:00 am – 2:00 pm.

On site across Vancouver, Burnaby, Richmond, New Westminster, Coquitlam, Surrey, Delta, Langley and Abbotsford — and across British Columbia by arrangement. Farsi-speaking clients are welcome.

Edgebander.ca is an independent service provider and is not affiliated with, authorized by or endorsed by Homag. Brand and model names are used only to describe the machines serviced.
© 2026 Edgebander.caHamidreza Rahimi (Mahyar) · Vancouver, BCPrivacy